Wireless magnetic sensor
RF RC M30 SW917NG KST LBT
Article no.: 1474235
Product features
Thermoplastic enclosure
sWave® wireless technology
Power supply by lithium battery
No wiring or cable laying required
Easy programming of receiver
Output signal can be individually configured at the receiver
LBT - Listen Before Talk firmware
Notes
2 mounting nuts are included in delivery.
The actuator is not included in the delivery of the switches.
This is available for sale within Australia/NZ only through our partner NHP Electrical engineering Products Pty. Ltd.
Technical data
General technical data
- Applied standards
- IEC 60947-5-1, CISPR 32:2015 + AMD1:2019; ARPANSA S-1:2021; AS/NZS 2772.2:2016 + AMD1:2018; ACMA Radiocommunications Equipment (General) Rules 2021; NZ RSM General User Radio Licence – Special Condition 23
- Enclosure
- PVC-C, grey
- Tightening torque
- mounting nut: max. 4 Nm
- Degree of protection
- IP67 (IEC/EN 60529)
- Type of installation
- flush, in not ferromagnetic material
- Safety class
- III
- Ambient temperature
- –20 °C … +65 °C
- Switching system
- Reed contact
- Rated switching distance sn
- M 100: 15 mm; M 30 Niro: 30 mm
- Hysteresis
- < 1 mm
- Switching frequency
- max. 5 Hz
- Actuating time
- min. 80 ms
- Note
- transmission of battery voltage and switching condition
Wireless technology
General
- Frequency
- 917.0 MHz (Australia)
- Data rate
- 66 kbps
- Channel bandwidth
- 550 kHz
- Modulation type
- 2-FSK
- Protocol
- sWave®
- Transmission power
- < 25 mW
- Wireless approvals
- Australia: |
Function
- Telegram rate
- max. 12000 telegrams with repetitions/h
- Wireless range
- max. 450 m outdoors, max. 40 m indoors
- Collision avoidance procedure
- LBT - Listen Before Talk software
- Note
- LBT – can be deactivated via radio receiver (e.g. in conjunction with repeaters)
status signal – can be individually configured via radio receiver (delivery state: without status signal)
Go to our different wireless receivers to find corresponding how-to videos.
Voltage supply
- Voltage source
- lithium battery CR 2032 (replaceable)
- System
- Lithium-MnO2
- Nominal voltage
- 3 V
- Nominal capacity
- 0.23 Ah
- Standby current
- < 2 µA (< 5 µA activated)
- Battery life
- depending on the switching frequency (typ. @ 20 °C)
10 s: 1.1 years; 100 s: 5.0 years; 1000 s: 7.6 years; without: 8.0 years
Dimensional drawing
Downloads
Variants / Options
The following variants / options are available on request:
Sensor based on GMR effect (RF GS M30 …)
Loading...
Wireless magnetic sensor
RF RC M30 SW917NG KST LBTArticle no.: 1474235
